LadderMaster will handle most all your Cage-Ladders for you... in seconds!
Cage-Ladders are drawn in real-time, real size (if it don't work here, it won't work in the shop!).
There are lots of materials to choose from, everything is parametricly connected.
All holes, allow for bolt clearances, using steel manual G.O.L's & Ga.'s.
It is so... easy!
Anyone can do it!
You can draw your Ladders in Elevation-view, Side-view, & 3 sectional-views, including a complete B.O.M..
But first you must decide what type of materials your Cage-Ladder will use.
Bracket section:
There are 2 sections in the Bracket section of LadderMaster (Wall & Base).
Wall Bracket section:
The "Edge dist" edit_box, is the distance from the wall to the inside of the main leg supports (moves the Cage-Ladder away/towards wall).
Then, pick the size from the "Size" drop_down_pick_box.
Don't forget to pick the foot length of the bracket, from the "Foot" drop_down_pick_box.
The "Qua." drop_down_pick_box, is grayed out at the time of this publication (but may be enabled, at the time of issue).
Last, the "Bolt" drop_down_pick_box, has a "Dummy Value" at the time of this publication (but may be enabled, at the time of issue).
Base Bracket section:
Then, pick the size from the "Size" drop_down_pick_box.
Don't forget to pick the foot length of the bracket, from the "Foot" drop_down_pick_box.
The "Qua." drop_down_pick_box, is grayed out at the time of this publication (but may be enabled, at the time of issue).
Last, the "Bolt" drop_down_pick_box, has a "Dummy Value" at the time of this publication (but may be enabled, at the time of issue).
The other sections will be explained later...
(pick "Next Sample" below)
This release (v1.0.0.0) will have only the options shown.
Other options added, as customers request them.
