This is a sample of
DansMark Software Solutions
LadderMaster


LadderMaster will handle most all your Cage-Ladders for you... in seconds!

Cage-Ladders are drawn in real-time, real size (if it don't work here, it won't work in the shop!).
There are lots of materials to choose from, everything is parametricly connected.

All holes, allow for bolt clearances, using steel manual G.O.L's & Ga.'s.

It is so... easy!
Anyone can do it!

You can draw your Ladders in Elevation-view, Side-view, & 3 sectional-views, including a complete B.O.M..

But first you must decide what type of materials your Cage-Ladder will use.


Legs section:

Pick the leg size needed from the "Size (D)" drop_down_list_box.
The size will be displayed at the letter "D" in the "Size & Material" section of the main dialog.

Next, enter the leg spacing in the "Width (out/out) (E)" edit_box.
The distance will be displayed at the letter "E" in the "Size & Material" section of the main dialog.

The other sections will be explained later...
(pick "Next Sample" below)




This release (v1.0.0.0) will have only the options shown.
Other options added, as customers request them.

Next Sample

  Copyright - © 1996-2005 DansMark Software Solutions - All rights reserved.